Payment & Shipping Terms:
|Product Name:||High Definition H.264 Automatic People Counter With Graphical User Interface||Storage:||Sd Card Slot X 2 (128GB/sd Card)|
|Video Interface:||Aviation Connector||Image Resolution:||4x720PAHD Or 4x960H/D1/HD1/CIF+1XIPC|
|Operation Menu:||Graphical User Interface(OSD Menu)||Video Input:||4 Channels|
|Type:||AHD Mobile DVR||Video Compression:||H. 264|
people counting system,
infrared counting system
The device supports 360 ° installation, please install the device in the suitable location according to the counter’s size of hole site. (Suggest installing horizontally to ensure that in extreme conditions the equipment can also work properly, taking into account the host of waterproof, moisture, lightning protection, to prevent car washing, moisture and other circumstances lead to car boot burned motherboard).
Connect the 6-pin white plug to the 6-pin power input port on the rear panel of the MDVR, while the red and black cables are directly connected to the battery of the vehicle, i.e. positive terminal and negative terminal respectively, or to the main power. The yellow cable is connected to ACC, the vehicle control circuit switch (used to start the vehicle motor). The unit will be enabled automatically when the car key is enabled and disabled when the key is disabled.
When the device is not installed in a vehicle (such as monitoring systems in bus station, logistic transfer) or under test, you can use a switching power above DC12V-5A to supply the mainframe. In this case, twist the red and yellow cables as a cable to connect it to the positive terminal, while the black one is connected to the negative terminal separately.
|Power supply||+8～+36V||8V～36V, Check the supply voltage of the vehicle battery before use; if it is supplied with more than 36V for a prolonged period, the device may be damaged.|
|Power output||12V||12V(+/-0.2V), max. current: 3A|
|ACC detection||≤4V||Power off|
|Video input impedance||75Ω||Each video input impedance: 75Ω|
|Video output voltage||2Vp-p||2VP-P CVBS output analog signal which should be adapted by 75Ω of input impedance from the display unit.|
|I/O interface||1V or below||Low level alarm|
|5V or above||High level alarm|
|Working temperature||-25℃ ~ 75℃||In a well-ventilated place|
Contact Person: Vera Long